2005年1月 3日

[vine-users:069479] Re: はじめまして

池谷と申します。

小林さんとまったく同じ症状か分かりませんが、うちのPCでも同様な事が起きております。

当方ではftpインストールしたのですが、
カーネルオプション(acpi=off apm=on)を指定しなくても
shutdown -h now や poweroff で自動的に電源が切れました。

一方、shutdown -r now や reboot でサーバを再起動をした場合ですが、
各種デーモンのプロセスは正常終了して、rebootのメッセージが表示されるのですが、


その後、マシンの再起動が行われず、フリーズします。(フリーズと言うかは疑問ですが・・・)

現状、メッセージが出た後にPCのリセットボタンを押してます(^^;...

----- Original Message -----
From: "Hiroki Kobayshi" CBC03089@xxxxx
To: "vine-users ML" <vine-users@xxxxx>
Sent: Monday, January 03, 2005 8:50 PM
Subject: [vine-users:069477] Re: はじめまして


> 小林です。
>
> 政さんの指示に従いまして変更しましたが、状況に変化はありませんでした。
>
> なおdmesgですが、以下の通りでした。
>
> Linux version 2.4.27-0vl7 (daisuke@xxxxx) (gcc バージョ
> ン 3.3.2 20031218 (Vine Linux 3.3.2-0vl8)) #1 2004年 10月 27日 水曜日
> 13:30:16 JST
> BIOS-provided physical RAM map:
> BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
> BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
> BIOS-e820: 00000000000e8c00 - 0000000000100000 (reserved)
> BIOS-e820: 0000000000100000 - 000000001fff0000 (usable)
> BIOS-e820: 000000001fff0000 - 000000001ffffc00 (ACPI data)
> BIOS-e820: 000000001ffffc00 - 0000000020000000 (ACPI NVS)
> BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved)
> 0MB HIGHMEM available.
> 511MB LOWMEM available.
> On node 0 totalpages: 131056
> zone(0): 4096 pages.
> zone(1): 126960 pages.
> zone(2): 0 pages.
> Kernel command line: BOOT_IMAGE=linux ro root=303 acpi=off apm=on noapic
> resume2=swap:/dev/hda5
> Local APIC disabled by BIOS -- reenabling.
> Could not enable APIC!
> Initializing CPU#0
> Detected 597.452 MHz processor.
> Console: colour VGA+ 80x25
> Calibrating delay loop... 1192.75 BogoMIPS
> Memory: 514204k/524224k available (2063k kernel code, 9632k reserved,
> 733k data, 160k init, 0k highmem)
> Dentry cache hash table entries: 65536 (order: 7, 524288 bytes)
> Inode cache hash table entries: 32768 (order: 6, 262144 bytes)
> Mount cache hash table entries: 512 (order: 0, 4096 bytes)
> Buffer cache hash table entries: 32768 (order: 5, 131072 bytes)
> Page-cache hash table entries: 131072 (order: 7, 524288 bytes)
> CPU: L1 I cache: 16K, L1 D cache: 16K
> CPU: L2 cache: 128K
> CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000
> CPU: Common caps: 0383f9ff 00000000 00000000 00000000
> CPU: Intel Celeron (Coppermine) stepping 06
> Enabling fast FPU save and restore... done.
> Enabling unmasked SIMD FPU exception support... done.
> Checking 'hlt' instruction... OK.
> POSIX conformance testing by UNIFIX
> mtrr: v1.41 (20040107) Richard Gooch (rgooch@xxxxx)
> mtrr: detected mtrr type: Intel
> ACPI: Subsystem revision 20040326
> ACPI: Interpreter disabled.
> PCI: PCI BIOS revision 2.10 entry at 0xfd9ce, last bus=1
> PCI: Using configuration type 1
> PCI: Probing PCI hardware
> PCI: Probing PCI hardware (bus 00)
> PCI: Using IRQ router PIIX/ICH [8086/7110] at 00:07.0
> PCI: Found IRQ 11 for device 00:07.2
> Limiting direct PCI/PCI transfers.
> Linux NET4.0 for Linux 2.4
> Based upon Swansea University Computer Society NET3.039
> Initializing RT netlink socket
> apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)
> powernow: AMD processor not detected.
> cpufreq: Intel(R) SpeedStep(TM) for this chipset not (yet) available.
> gx-suspmod: error: no MediaGX/Geode processor found!
> Software Suspend LZF Compression Driver v1.0
> Software Suspend Swap Writer v1.0
> Starting kswapd
> VFS: Disk quotas vdquot_6.5.1
> Journalled Block Device driver loaded
> pty: 256 Unix98 ptys configured
> Serial driver version 5.1 (2004-01-29) with MANY_PORTS SHARE_IRQ
> SERIAL_PCI enabled
> ttyS00 at 0x03f8 (irq = 4) is a 16550A
> PCI: Enabling device 00:0b.1 (0000 -> 0003)
> PCI: Assigned IRQ 10 for device 00:0b.1
> PCI: Sharing IRQ 10 with 00:0b.0
> Redundant entry in serial pci_table. Please send the output of
> lspci -vv, this message (115d,00d3,8086,2411)
> and the manufacturer and name of serial board or modem board
> to serial-pci-info@xxxxx
> register_serial(): autoconfig failed
> Floppy drive(s): fd0 is 1.44M
> FDC 0 is a National Semiconductor PC87306
> RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
> loop: loaded (max 8 devices)
> Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
> ide: Assuming 33MHz system bus speed for PIO modes; override with
> idebus=xx
> PIIX4: IDE controller at PCI slot 00:07.1
> PIIX4: chipset revision 1
> PIIX4: not 100% native mode: will probe irqs later
> ide0: BM-DMA at 0x1000-0x1007, BIOS settings: hda:DMA, hdb:pio
> ide1: BM-DMA at 0x1008-0x100f, BIOS settings: hdc:DMA, hdd:pio
> hda: HTS548040M9AT00, ATA DISK drive
> blk: queue c0421a00, I/O limit 4095Mb (mask 0xffffffff)
> hdc: MATSHITA CR-271, ATAPI CD/DVD-ROM drive
> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> ide1 at 0x170-0x177,0x376 on irq 15
> hda: attached ide-disk driver.
> hda: host protected area => 1
> hda: 78140160 sectors (40008 MB) w/7877KiB Cache, CHS=4864/255/63,
> UDMA(33)
> hdc: attached ide-cdrom driver.
> hdc: ATAPI 24X CD-ROM drive, 128kB Cache, DMA
> Uniform CD-ROM driver Revision: 3.12
> Partition check:
> hda: hda1 hda2 hda3 hda4 < hda5 hda6 >
> usb.c: registered new driver usbdevfs
> usb.c: registered new driver hub
> mice: PS/2 mouse device common for all mice
> md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
> md: Autodetecting RAID arrays.
> md: autorun ...
> md: ... autorun DONE.
> Initializing Cryptographic API
> NET4: Linux TCP/IP 1.0 for NET4.0
> IP Protocols: ICMP, UDP, TCP, IGMP
> IP: routing cache hash table of 4096 buckets, 32Kbytes
> TCP: Hash tables configured (established 32768 bind 65536)
> Linux IP multicast router 0.06 plus PIM-SM
> NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
> Software Suspend 2.0.0.100: Attempting to set blocksize for 305 to 4096.
> Software Suspend 2.0.0.100: Swap space signature found.
> Software Suspend 2.0.0.100: Suspending enabled.
> Software Suspend 2.0.0.100: Checking for image...
> Software Suspend 2.0.0.100: This is normal swap space.
> RAMDISK: Compressed image found at block 0
> Freeing initrd memory: 111k freed
> VFS: Mounted root (ext2 filesystem).
> kjournald starting. Commit interval 5 seconds
> EXT3-fs: mounted filesystem with ordered data mode.
> VFS: Mounted root (ext3 filesystem) readonly.
> Trying to move old root to /initrd ... okay
> Freeing unused kernel memory: 160k freed
> Real Time Clock Driver v1.10f
> Adding Swap: 522072k swap-space (priority -1)
> EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,3), internal journal
> PCI: Enabling device 00:0c.0 (0000 -> 0003)
> PCI: Assigned IRQ 5 for device 00:0c.0
> ymfpci: YMF744 at 0xfe028000 IRQ 5
> ac97_codec: AC97 Audio codec, id: AKM2 (Asahi Kasei AK4543)
> kjournald starting. Commit interval 5 seconds
> EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,2), internal journal
> EXT3-fs: mounted filesystem with ordered data mode.
>
>
>


投稿者 xml-rpc : 2005年1月 3日 22:36
役に立ちました?:
過去のフィードバック 平均:(0) 総合:(0) 投票回数:(0)
本記事へのTrackback: http://hoop.euqset.org/blog/mt-tb2006.cgi/11304
トラックバック
コメント
コメントする




画像の中に見える文字を入力してください。