2008年11月 9日

[gentoojp-users:02115] Re: XenのゲストOSの起動

はじめまして。
Nutzと申します。

私の場合、DomUの/etc/inittabへ

# TERMINALS
co:2345:respawn:/sbin/agetty xvc0 9600 vt100-nav # ここを追加
c1:12345:respawn:/sbin/agetty 38400 tty1 linux


としてなんとか使えるようにしました。
(起動はしているがコンソールへの出力が無い状態だったので)

ただ、この方法だとサービスの起動状態(Starting hoge [ok])が
コンソールには表示されません。
virt-managerのグラフィカルコンソールには表示が出るのですが・・。

しっくり来ませんが、今はこれで使用しています。

> はじめましてtabataと申します
>
> GentooをのXenをインストールしたのですがDomUを起動が途中で停止してしまい
> 起動できません
>
> DomUの起動が「Freeing unused kernel memory: 216k freed」で止まってしまいます
> とこで止まっているのか追って見たのですが、どうやら /bin/dmesを実行する辺りで
> 出力が停止してしまいます
>
> 設定がよろしくないと思うのですが、原因を突き止める方法を教えていただきた
> いです
>
> よろしくお願いします
>
> 【 起動ログ 】
> Using config file "/etc/xen/gentoo-vgt1.conf".
> Started domain genv1
> Linux version 2.6.18-xen-r12 (root@xxxxx) (gcc version 4.1.2 (Gentoo
> 4.1.2 p1.1)) #3 SMP Sun Nov 9 01:52:05 Local time zone must be set--see
> zic m
> BIOS-provided physical RAM map:
> Xen: 0000000000000000 - 0000000020800000 (usable)
> 520MB LOWMEM available.
> NX (Execute Disable) protection: active
> Allocating PCI resources starting at 30000000 (gap: 20800000:df800000)
> Detected 2793.175 MHz processor.
> Built 1 zonelists. Total pages: 133120
> Kernel command line: root=/dev/hda1 3
> Enabling fast FPU save and restore... done.
> Enabling unmasked SIMD FPU exception support... done.
> Initializing CPU#0
> PID hash table entries: 4096 (order: 12, 16384 bytes)
> Xen reported: 2793.000 MHz processor.
> Console: colour dummy device 80x25
> Dentry cache hash table entries: 131072 (order: 7, 524288 bytes)
> Inode-cache hash table entries: 65536 (order: 6, 262144 bytes)
> Software IO TLB disabled
> vmalloc area: e1000000-f56f9000, maxmem 2d7fe000
> Memory: 512212k/532480k available (3152k kernel code, 11956k reserved,
> 1344k data, 216k init, 0k highmem)
> Checking if this processor honours the WP bit even in supervisor mode... Ok.
> Calibrating delay using timer specific routine.. 5589.97 BogoMIPS
> (lpj=11179954)
> Mount-cache hash table entries: 512
> CPU: Trace cache: 12K uops, L1 D cache: 16K
> CPU: L2 cache: 1024K
> Checking 'hlt' instruction... OK.
> SMP alternatives: switching to UP code
> Freeing SMP alternatives: 20k freed
> Brought up 1 CPUs
> migration_cost=0
> NET: Registered protocol family 16
> PCI: setting up Xen PCI frontend stub
> suspend: event channel 6
> xen_mem: Initialising balloon driver.
> SCSI subsystem initialized
> usbcore: registered new driver usbfs
> usbcore: registered new driver hub
> PCI: System does not support PCI
> PCI: System does not support PCI
> NET: Registered protocol family 2
> IP route cache hash table entries: 32768 (order: 5, 131072 bytes)
> TCP established hash table entries: 131072 (order: 8, 1048576 bytes)
> TCP bind hash table entries: 65536 (order: 7, 524288 bytes)
> TCP: Hash tables configured (established 131072 bind 65536)
> TCP reno registered
> VFS: Disk quotas dquot_6.5.1
> Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
> Installing knfsd (copyright (C) 1996 okir@xxxxx).
> NTFS driver 2.1.27 [Flags: R/W].
> Initializing Cryptographic API
> io scheduler noop registered
> io scheduler anticipatory registered (default)
> io scheduler deadline registered
> io scheduler cfq registered
> rtc: IRQ 8 is not free.
> Linux agpgart interface v0.101 (c) Dave Jones
> Hangcheck: starting hangcheck timer 0.9.0 (tick is 180 seconds, margin
> is 60 seconds).
> Hangcheck: Using get_cycles().
> Floppy drive(s): fd0 is unknown type 15 (usb?), fd1 is unknown type 15
> (usb?)
> Failed to obtain physical IRQ 6
> floppy0: Unable to grab DMA2 for the floppy driver
> floppy0: no floppy controllers found
> RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
> loop: loaded (max 8 devices)
> Intel(R) PRO/1000 Network Driver - version 7.1.9-k4
> Copyright (c) 1999-2006 Intel Corporation.
> e100: Intel(R) PRO/100 Network Driver, 3.5.10-k2-NAPI
> e100: Copyright(c) 1999-2005 Intel Corporation
> forcedeth.c: Reverse Engineered nForce ethernet driver. Version 0.56.
> netconsole: not configured, aborting
> Xen virtual console successfully installed as xvc0
> Event-channel device installed.
> netfront: Initialising virtual ethernet driver.
> Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
> ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
> xen-vbd: registered block device major 3
> blkfront: hda1: barriers enabled
> 3ware Storage Controller device driver for Linux v1.26.02.001.
> Fusion MPT base driver 3.04.01
> Copyright (c) 1999-2005 LSI Logic Corporation
> Fusion MPT SPI Host driver 3.04.01
> ieee1394: raw1394: /dev/raw1394 device initialized
> usbmon: debugfs is not available
> USB Universal Host Controller Interface driver v3.0
> usbcore: registered new driver usblp
> drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
> Initializing USB Mass Storage driver...
> usbcore: registered new driver usb-storage
> USB Mass Storage support registered.
> usbcore: registered new driver usbhid
> drivers/usb/input/hid-core.c: v2.6:USB HID core driver
> i8042.c: No controller found.
> mice: PS/2 mouse device common for all mice
> Intel 810 + AC97 Audio, version 1.01, 19:04:29 Nov 8 2008
> xenoprofile_init: ret 0, events 4, xenoprof_is_primary 0
> Netfilter messages via NETLINK v0.30.
> nf_conntrack version 0.5.0 (4160 buckets, 33280 max)
> ctnetlink v0.93: registering with nfnetlink.
> ip_tables: (C) 2000-2006 Netfilter Core Team
> ClusterIP Version 0.8 loaded successfully
> arp_tables: (C) 2002 David S. Miller
> TCP bic registered
> NET: Registered protocol family 1
> NET: Registered protocol family 10
> IPv6 over IPv4 tunneling driver
> ip6_tables: (C) 2000-2006 Netfilter Core Team
> NET: Registered protocol family 17
> Bridge firewalling registered
> Ebtables v2.0 registered
> ebt_ulog: not logging via ulog since somebody else already registered
> for PF_BRIDGE
> Using IPI Shortcut mode
> XENBUS: Device with no driver: device/console/0
> kjournald starting. Commit interval 5 seconds
> EXT3 FS on hda1, internal journal
> EXT3-fs: mounted filesystem with ordered data mode.
> VFS: Mounted root (ext3 filesystem).
> Freeing unused kernel memory: 216k freed
>
>
>
>

投稿者 xml-rpc : 2008年11月 9日 09:16
役に立ちました?:
過去のフィードバック 平均:(0) 総合:(0) 投票回数:(0)
本記事へのTrackback: http://hoop.euqset.org/blog/mt-tb2006.cgi/78843
トラックバック
コメント
コメントする




画像の中に見える文字を入力してください。