2008年11月 9日

[gentoojp-users:02114] XenのゲストOSの起動

はじめましてtabataと申します

GentooをのXenをインストールしたのですがDomUを起動が途中で停止してしまい
起動できません

DomUの起動が「Freeing unused kernel memory: 216k freed」で止まってしまいます
とこで止まっているのか追って見たのですが、どうやら /bin/dmesを実行する辺りで
出力が停止してしまいます


設定がよろしくないと思うのですが、原因を突き止める方法を教えていただきた
いです

よろしくお願いします

【 起動ログ 】
Using config file "/etc/xen/gentoo-vgt1.conf".
Started domain genv1
Linux version 2.6.18-xen-r12 (root@xxxxx) (gcc version 4.1.2 (Gentoo
4.1.2 p1.1)) #3 SMP Sun Nov 9 01:52:05 Local time zone must be set--see
zic m
BIOS-provided physical RAM map:
Xen: 0000000000000000 - 0000000020800000 (usable)
520MB LOWMEM available.
NX (Execute Disable) protection: active
Allocating PCI resources starting at 30000000 (gap: 20800000:df800000)
Detected 2793.175 MHz processor.
Built 1 zonelists. Total pages: 133120
Kernel command line: root=/dev/hda1 3
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Initializing CPU#0
PID hash table entries: 4096 (order: 12, 16384 bytes)
Xen reported: 2793.000 MHz processor.
Console: colour dummy device 80x25
Dentry cache hash table entries: 131072 (order: 7, 524288 bytes)
Inode-cache hash table entries: 65536 (order: 6, 262144 bytes)
Software IO TLB disabled
vmalloc area: e1000000-f56f9000, maxmem 2d7fe000
Memory: 512212k/532480k available (3152k kernel code, 11956k reserved,
1344k data, 216k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay using timer specific routine.. 5589.97 BogoMIPS
(lpj=11179954)
Mount-cache hash table entries: 512
CPU: Trace cache: 12K uops, L1 D cache: 16K
CPU: L2 cache: 1024K
Checking 'hlt' instruction... OK.
SMP alternatives: switching to UP code
Freeing SMP alternatives: 20k freed
Brought up 1 CPUs
migration_cost=0
NET: Registered protocol family 16
PCI: setting up Xen PCI frontend stub
suspend: event channel 6
xen_mem: Initialising balloon driver.
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
PCI: System does not support PCI
PCI: System does not support PCI
NET: Registered protocol family 2
IP route cache hash table entries: 32768 (order: 5, 131072 bytes)
TCP established hash table entries: 131072 (order: 8, 1048576 bytes)
TCP bind hash table entries: 65536 (order: 7, 524288 bytes)
TCP: Hash tables configured (established 131072 bind 65536)
TCP reno registered
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
Installing knfsd (copyright (C) 1996 okir@xxxxx).
NTFS driver 2.1.27 [Flags: R/W].
Initializing Cryptographic API
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
rtc: IRQ 8 is not free.
Linux agpgart interface v0.101 (c) Dave Jones
Hangcheck: starting hangcheck timer 0.9.0 (tick is 180 seconds, margin
is 60 seconds).
Hangcheck: Using get_cycles().
Floppy drive(s): fd0 is unknown type 15 (usb?), fd1 is unknown type 15
(usb?)
Failed to obtain physical IRQ 6
floppy0: Unable to grab DMA2 for the floppy driver
floppy0: no floppy controllers found
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
loop: loaded (max 8 devices)
Intel(R) PRO/1000 Network Driver - version 7.1.9-k4
Copyright (c) 1999-2006 Intel Corporation.
e100: Intel(R) PRO/100 Network Driver, 3.5.10-k2-NAPI
e100: Copyright(c) 1999-2005 Intel Corporation
forcedeth.c: Reverse Engineered nForce ethernet driver. Version 0.56.
netconsole: not configured, aborting
Xen virtual console successfully installed as xvc0
Event-channel device installed.
netfront: Initialising virtual ethernet driver.
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
xen-vbd: registered block device major 3
blkfront: hda1: barriers enabled
3ware Storage Controller device driver for Linux v1.26.02.001.
Fusion MPT base driver 3.04.01
Copyright (c) 1999-2005 LSI Logic Corporation
Fusion MPT SPI Host driver 3.04.01
ieee1394: raw1394: /dev/raw1394 device initialized
usbmon: debugfs is not available
USB Universal Host Controller Interface driver v3.0
usbcore: registered new driver usblp
drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.6:USB HID core driver
i8042.c: No controller found.
mice: PS/2 mouse device common for all mice
Intel 810 + AC97 Audio, version 1.01, 19:04:29 Nov 8 2008
xenoprofile_init: ret 0, events 4, xenoprof_is_primary 0
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (4160 buckets, 33280 max)
ctnetlink v0.93: registering with nfnetlink.
ip_tables: (C) 2000-2006 Netfilter Core Team
ClusterIP Version 0.8 loaded successfully
arp_tables: (C) 2002 David S. Miller
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 10
IPv6 over IPv4 tunneling driver
ip6_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 17
Bridge firewalling registered
Ebtables v2.0 registered
ebt_ulog: not logging via ulog since somebody else already registered
for PF_BRIDGE
Using IPI Shortcut mode
XENBUS: Device with no driver: device/console/0
kjournald starting. Commit interval 5 seconds
EXT3 FS on hda1, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem).
Freeing unused kernel memory: 216k freed


投稿者 xml-rpc : 2008年11月 9日 02:34
役に立ちました?:
過去のフィードバック 平均:(0) 総合:(0) 投票回数:(0)
本記事へのTrackback: http://hoop.euqset.org/blog/mt-tb2006.cgi/78842
トラックバック
コメント
コメントする




画像の中に見える文字を入力してください。